Đèn LED logo xe hơi Toyota FLC tùy chọn màu sắc

Giới thiệu Đèn LED logo xe hơi Toyota FLC tùy chọn màu sắc

Features
1.Condition: 100% Brand New
2.Waterproof
3.Light-emitting car standard
4.Decorate the original car emblem
Description
Installation:the led light paste onto the car,connect the wire with original light wire.
The power: DC12V +/-10%
LED light Color：Red/Blue/white
Size : 10X6.8cm、11X7.5cm、12X8cm、13X8.9CM、14X10cm、15X10cm
Voltage: DC 12V + / - 10%
Current: 1.13-1.14
Suitable for:
Toyota RAV4/REIZ 2011/PRADO FIT:10.0cm*6.8cm

Toyota COROLLA /CROWN/YARIS/COROLLA/VIOS FIT:11.0*7.5CM
Toyota COROLLA/CROWN/NEW VIOS/Highlander/COROLLA FIT:12.0*8.0cm
Toyota YARIS/CAMRYS 2008/HIACE FIT:13.0*8.9cm
Yoyota LANDCRUISER/ALRHARD/CAMRYS/EZ/COROLLA/REIZ/VIOS FIT:14.0*10.0cm
Toyota REIZ/YARIS/ALRHARD FIT:15.0*10.0cm
Toyota PRADO/RAV4/Highlander FIT:16.1*11.0cm
Introduction of function:
1. This product should be installed in the original position to replace the original logo(at the back of the car)
2. High quality water plating car badge, Laser and Reflective mirror
3. When the license plate lamp is turned on,the car logo light will be turn on too, which shines the logo in the night .
4. Special waterproof and dustproof design!
Installation:
1. First, spread a towel beside the car trunk (in order not to scratch the car body), with a flat head screwdriver, pry the car logo
2. Tear off the double-sided adhesive: pry it from the car body with moderate strength, steps by steps, slowly pry it down, then clean up the logo and car body .
3. Use crosshead screw-driver to uninstall the board inner the trunk, There are clips at somewhere, please carefully remove the insulation board ,you can see all kinds of lines.
4. Pass the power line of Car logo lamp through one of the logo location hole, pass inside the trunk and tear off the back of vehicle logo light
5. As the car logo lamp has installed, now connect the power supply.The logo lamp should connected with the light power supply of the rear license plate ,so that when turn on the small night lamp, the car logo lamp is also turned on Find the license plate lamp power connector
6. First pull the plug, and strip a opening separately of the positive and negative pole to show the wire core, Connect the lines(red to red and black to black) , don't forget to wind then with insulating tape, Also, you need to plug back and set the insulation board to the trunk again!
Package Include
1PC Car LED Lamp
Notice
1. Please allowed 1-5mm differences due to manual measurement, thanks.
2. Due to the difference between different monitors, the picture may not reflect the actual color of the item.
3.Pls noted some car front logo is different with the back one ,before you confirm the order that you could following the size to checking it.
If you have any doubt , please feel free to contact with us~
Hope you enjoy your shopping time ~
#Toyota #Toyota car lights #light #Lights #Car accessories #Automotive interior #Toyota front light #cars #car #RAV4 #COROLLA